GAVIN-6C Instruction Manual
- 3 -
This product is made of precision electronic components and mechanical
parts, please keep away from wet conditions, to prevent the components
damage from water and cause a failure which would lead to a crash.
Always keep away from hot conditions.
This product is made of precision electronic components and mechanical
parts, please keep away from hot conditions, to avoid distortion or damage.
Precautions before Flight:
Always make sure that all servos in the model work properly following the
transmitter stick movements prior to flight. And make sure that all switches
work properly as well.
Always check the remaining capacity of both the transmitter and receiver
batteries before each flying session prior to flight. Low battery capacity will
cause loss of control and a crash.
Always perform a range test before each flying session.
Always check the operation of each control surface before each flying session.
When using the trainer function, please check both the instructor and student
transmitters.
For safety reasons, always set fail safe functions before each flying session.
Especially set the throttle channel fail safe function.
Precautions during Flight:
Never grasp the transmitter antenna during flight. Otherwise, the transmitter
output power will reduce drastically.
Do not point the antenna directly toward the aircraft during flight. When
pointing the antenna directly, the transmitter output is the weakest. The
strong radio wave radiate from the side of the transmitter antenna.
Never turn on and off the power switch of transmitter during flight or while the
engine or motor is running.
Do not touch the engine, motor or other heating device or component during
and immediately after use. These devices or components may become hot
during use.
To Next Page
Loading...