Develop ineo 367 - When It Is Time to Replace a Developing Unit; When a Waste Toner Box Is Full

ineo 367/287/227 5-9
5.4 When a message appears to replace consumables or carry out cleaning
5
NOTICE
A Drum Unit must not be replaced before the relevant message appears.
Tips
- By the factory default status, this message is displayed only in some area.
- The settings by the service representative are required to display a message about Drum Unit. For de-
tails, contact your service representative.
When it is time to replace a Developing Unit
When it is time to replace a Developing Unit, a message appears to prompt you to contact your service rep-
resentative. If the message appears, contact your service representative.
Tips
- By the factory default status, this message is displayed only in some area.
- The settings by the service representative are required to display a message about Developing Unit.
For details, contact your service representative.
When a Waste Toner Box is full
When the Waste Toner Box is full, a message appears to prompt you to replace it (at replacement by user).
Tap [Start Guidance], then follow the displayed guidance to take an action.