Develop ineo 367 - Replacing a Drum Unit

5-12 ineo 367/287/227
When a message appears to replace consumables or carry out cleaning
5
5.4
5.4.3 Replacing a Drum Unit
Tips
- After Drum Unit replacement step 1 has been completed, check that the circled lock is located at the
position indicated by a dashed line, then execute step 2. If the circled lock is not located at the position
indicated by a dashed line, press in the blue knob of the Drum Unit to release the lock.
- Your service representative will collect your used Drum Unit. Put it in a black plastic bag and store it
in a box by itself.
- A Drum Unit may be damaged due to exposure to light. Do not take a Drum Unit out of a black plastic
bag until just before it is to installed.
- If a Drum Unit was replaced, be sure to adjust the gradation. For details on how to adjust the gradation,
refer to the User's Guide CD/DVD.
7CAUTION
- The inside of this product has areas subject to high temperature, which may cause burns.
When checking the inside of the unit for malfunctions such as a paper misfeed, do not touch the loca-
tions (around the fusing unit, etc.) which are indicated by a "Caution HOT" caution label. A burn could
result.
Unpacking the drum unit