ineo 367/287/227 2-9
2.3 About this machine
2
No. Name Description
1 Main unit Scans the original in the scanner section, and prints a scanned im-
age in the printer section.
2 Original Cover OC-514 Used to fix the loaded originals.
3 Reverse Automatic Doc-
ument Feeder DF-628
Automatically feeds and scans originals by page.
4 Fax Kit FK-513 Required to use the fax function.
The Hard Disk is optional in some areas. When you use the fax
function, the optional Hard Disk must also be installed in this ma-
chine.
5 Clean Unit CU-101 Collects small particles (UFP) generated in this machine to prevent
them from escaping this machine.
The Mount Kit MK-747 is required to install Clean Unit CU-101.
6 Mount Kit MK-747 This unit is required to install Clean Unit CU-101.
7 Authentication Unit
AU-102
Performs user authentication by scanning vein patterns in the fin-
ger.
To install the Authentication Unit AU-102, the Local Interface Kit
EK-608 or Local Interface Kit EK-609 is required in addition to the
Working Table WT-506.
8 Authentication Unit
AU-201S
Performs user authentication by scanning information recorded on
the IC card.
To install the Authentication Unit AU-201S, the Local Interface
Kit EK-608 or Local Interface Kit EK-609 is required in addition to
the Mount Kit MK-735.
This unit can also be installed on the Working Table WT-506.
9 Working Table WT-506 Provides an area to temporarily place an original or other materials.
This is also used when the Authentication Unit AU-102 or Authen-
tication Unit AU-201S is installed.
10 Keypad KP-101 It is equipped on the side of the Control Panel. Allows you to enter
numbers by using the Hardware Keypad.
11 Keyboard Holder KH-102 Install this holder to use an external keyboard.
12 Desk DK-513 Used to place this machine on the floor.
13 Paper Feed Cabinet
PC-413
Can load up to 2500 sheets of 8-1/2 e 11 (A4) size paper.
14 Paper Feed Cabinet
PC-213
Can load up to 500 sheets respectively into the top and bottom
trays.
15
Paper Feed Cabinet
PC-113
Can load up to 500 sheets into the top tray. (The bottom tray is a
storage box.)
16 Finisher FS-534 Sorts, groups, or staples output sheets as required. To install the
Finisher FS-534, the Relay Unit RU-514 is required. Also, Desk
DK-513, Paper Feed Cabinet PC-413, Paper Feed Cabinet
PC-113, or Paper Feed Cabinet PC-213 must be installed on this
machine.
17 Saddle Stitcher SD-511 Used to add the center staple function to the Finisher FS-534.
18 Punch Kit PK-520 Used to add the punch function to the Finisher FS-534.
19 Relay Unit RU-514 Required to install the Finisher FS-534.
20 Finisher FS-533 Sorts, groups, or staples output sheets as required. This unit can be
installed in this machine.
The Mount Kit MK-602 is required to install the Finisher FS-533.
21 Mount Kit MK-602 Required to install the Finisher FS-533.
22 Punch Kit PK-519 Used to add the punch function to the Finisher FS-533.
23 Job Separator JS-506 Used to separate output sheets into two trays in the body of the ma-
chine.
To Next Page
Loading...
