10 • Next Sensor Session | Dexcom G7 User Guide 91
Remove while using sensor
To remove old sensors from the Bluetooth connections list while you are wearing one,
follow the above steps and keep these tips in mind:
All Dexcom sensors are listed as not connected, even the current one. The current
sensor’s status changes to connected during the few seconds every 5 minutes when
it’s sending your sensor reading to your phone. If you watch the list for up to 5
minutes, you’ll see which sensor is the current one.
Don’t worry if you remove the current sensor. Within 5 minutes, the sensor will send
your next sensor reading to your phone and the sensor will reappear in the Bluetooth
connections list. (If you use an iPhone, it will prompt you to re-pair the sensor–no
pairing code needed. Android phones do this automatically.)
To Next Page
Loading...
