Interfaces Wireless Wide Area Networks (WWANs)
IX10 User Guide
101
(config)> network interface my_wwan surelink advanced interface_
gateway hostname/IP_address
(config)>
8. Save the configuration and apply the change:
(config network interface my_wwan ipv4 surelink)> save
Configuration saved.
>
9. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Disable SureLink
If your device uses a private APN with no Internet access or has a restricted WAN connection that
doesn't allow DNS resolution, you can disable SureLink connectivity tests. You can also reconfigure
SureLink to disable the DNS test and use one or more other tests.
Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in Use Digi Remote Manager to view and manage your
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
To Next Page
Loading...
Need help?
General
