Services Configure DNS
IX10 User Guide
504
referred to by packet
filtering rules and access control lists.
Additional Configuration
--------------------------------------------------------
-----------------------
any
dynamic_routes
edge
external
internal
ipsec
loopback
setup
(config)>
Repeat this step to include additional firewall zones.
4. (Optional) Configure Multicast DNS (mDNS)
mDNS is a protocol that resolves host names in small networks that do not have a DNS server.
mDNS is disabled by default. To enable:
(config)> service telnet mdns enable true
(config>
5. (Optional) Set the port number for this service.
The default setting of 23 normally should not be changed.
(config)> service telnet port 25
(config)>
6. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
7. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure DNS
The IX10 device includes a caching DNS server which forwards queries to the DNS servers that are
associated with the network interfaces, and caches the results. This server is used within the device,
and cannot be disabled. Use the access control list to restrict external access to this server.
Required configuration items
n
Configure access control for the DNS service.
To Next Page
Loading...
Need help?
General
