Digi IX10 User Manual

Routing Virtual Router Redundancy Protocol (VRRP)
IX10 User Guide
305
4. Set https://remotemanager.digi.com as the hostname to ping:
(config network interface eth ipv4 surelink target 0)> ping_host
https://remotemanager.digi.com(config network interface eth ipv4 surelink
target 0)>
Task 5: Configure the DHCP server for ETH on device two
1. Type ... to return to the root of the configuration prompt:
(config network interface eth ipv4 surelink target 0)> ...
(config)>
2. Set the start and end addresses of the DHCP pool to use to assign DHCP addresses to clients:
a. Set the start address to 200:
(config)> network interface eth ipv4 dhcp_server lease_start 200
(config)>
b. Set the end address to 250:
(config)> network interface eth ipv4 dhcp_server lease_end 250
(config)>
3. Set the DHCP server gateway type to custom:
(config)> network interface eth ipv4 dhcp_server advanced gateway custom
(config)>
4. Set the custom gateway to 192.168.3.3:
(config)> network interface eth ipv4 dhcp_server advanced gateway_custom
192.168.3.3
(config)>
5. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Show VRRP status and statistics
This section describes how to display VRRPstatus and statistics for a IX10 device. VRRP status is
available from the Web UI only.
Web

Digi IX10 Specifications

General

Brand	Digi
Model	IX10
Category	Network Router
Language	English