System administration Configure the speed of your Ethernet port
IX10 User Guide
846
2. Connect the PC's Ethernet port to the Ethernet port on your IX10 device.
3. Open a telnet session and connect to the IX10 device at the IP address of 192.168.210.1.
4. Log into the device:
n
Username: admin
n
Password: The default unique password for your device is printed on the device label.
5. At the shell prompt, type:
# rm /etc/config/.nocrypt
# flatfsd -i
This will re-enable encryption and leave the device at its factory default setting.
Configure the speed of your Ethernet port
You can configure the speed of your IX10 device's Ethernet port.
Web
To Next Page
Loading...
