Routing Virtual Router Redundancy Protocol (VRRP)
IX10 User Guide
295
For example, to set interface_timeout to ten minutes, enter either 10m or
600s:
(config network interface eth ipv4 surelink target 0)>
interface_timeout 600s
(config network interface eth ipv4 surelink target 0)>
The default is 60 seconds.
9. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
10. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Example: VRRP/VRRP+ configuration
This example configuration creates a VRRP pool containing two IX10 devices:
Configure device one (master device)
Web
Task 1: Configure VRRP on device one
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
To Next Page
Loading...
