Interfaces Show SureLink status and statistics
IX10 User Guide
180
b. Add the device:
(config network vlan vlan1)> device /network/device/
(config network vlan vlan1)>
5. Set the VLANID:
(config network vlan vlan1)> id value
where value is an integer between 1 and 4095.
6. Save the configuration and apply the change:
(config network vlan vlan1)> save
Configuration saved.
>
7. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Show SureLink status and statistics
You can show SureLink status for all interfaces, or for an individual interface. You can also show
Surelink status for ipsec tunnels and OpenVPN clients.
SureLink status is only available from the Admin CLI.
Command line
Show SureLink State
To show the current state of SureLink for the IX10 device, use the show surelink state command:
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX10
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the Admin CLIprompt, type:
> show surelink state
Test on network.interface.eth1.ipv6 with condition: one
dns_configured (n);
network.interface.eth1.ipv6; -> update_routing_table
ACTION ATTEMPTS STATUS
restart_interface 00/01 [FAILED]
update_routing_table 00/01
Test on network.interface.modem.ipv4 with condition: all
dns_configured (n);
To Next Page
Loading...
Need help?
General
