Digi IX10 User Manual

Routing Show the routing table
IX10 User Guide
276
b. Enable a routing service that will be used. For example, to enable the RIP service:
(config)> network route service rip enable true
(config)>
c. Complete the configuration of the routing service. For example, use the ? to view the
available parameters for the RIPservice:
(config)> network route service rip ?
Parameters Current Value
---------------------------------------------------------------------
----------
ecmp false Allow ECMP
enable true Enable
Additional Configuration
---------------------------------------------------------------------
----------
interface Interfaces
neighbour Neighbours
redis Route redistribution
timer Timers
(config)>
5. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Show the routing table
To display the routing table:
Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in Use Digi Remote Manager to view and manage your
device.
b. Click the Device ID.

Digi IX10 Specifications

General

Brand	Digi
Model	IX10
Category	Network Router
Language	English