Digi IX10 User Manual

Interfaces Local Area Networks (LANs)
IX10 User Guide
155
Weight
---------------- ----- ------- ------ -------- -------- ------ --
----
defaultip IPv4 up static setup eth 10 10
defaultlinklocal IPv4 up static setup eth 0 10
eth IPv4 up static internal eth 5 10
eth IPv6 up static internal eth 5 10
loopback IPv4 up static loopback loopback 0 10
modem IPv4 up modem external wwan1 3 10
modem IPv6 down modem external wwan1 3 10
>
4. Enter show network interface name at the Admin CLI prompt to display additional
information about a specific LAN. For example, to display information about ETH, enter show
network interface eth:
> show network interface eth
lan1 Interface Status
---------------------
Device : eth
Zone : internal
IPv4 Status : up
IPv4 Type : static
IPv4 Address(es) : 192.168.2.1/24
IPv4 Gateway :
IPv4 MTU : 1500
IPv4 Metric : 5
IPv4 Weight : 10
IPv4 DNS Server(s) :
IPv6 Status : up
IPv6 Type : prefix
IPv6 Address(es) : fd00:2704::1/48
IPv6 Gateway :
IPv6 MTU : 1500
IPv6 Metric : 5
IPv6 Weight : 10
IPv6 DNS Server(s) :
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Delete a LAN
Follow this procedure to delete any LANs that have been added to the system. You cannot delete the
preconfigured LAN, LAN1.

Digi IX10 Specifications

General

Brand	Digi
Model	IX10
Category	Network Router
Language	English