Digi IX10

Firmware configuration Using the command line
IX10 User Guide
52
Access selection menu:
a: Admin CLI
s: Shell
q: Quit
Select access or quit [admin] :
Type a or admin to access the IX10 command line.
You will now be connected to the Admin CLI:
Connecting now...
Press Tab to autocomplete commands
Press '?' for a list of commands and details
Type 'help' for details on navigating the CLI
Type 'exit' to disconnect from the Admin CLI
>
See Command line interface for detailed instructions on using the command line interface.
Exit the command line interface
Command line
1. At the command prompt, type exit.
> exit
2. Depending on the device configuration, you may be presented with another menu, for
example:
Access selection menu:
a: Admin CLI
s: Shell
q: Quit
Select access or quit [admin] :
Type q or quit to exit.