Firewall Packet filtering
IX10 User Guide
757
Packet filtering
Configure packet filtering
Required configuration items
n
The action that the packet filtering rule will perform, either Accept, Reject, or Drop.
n
The source firewall zone: Packets originating from interfaces on this zone will be monitored by
this rule.
n
The destination firewall zone: Packets destined for interfaces on this zone will be accepted,
rejected, or dropped by this rule.
Additional configuration requirements
n
A label for the rule.
n
The IP version to be matched, either IPv4, IPv6, or Any.
n
The protocol to be matched, one of:
l
TCP
l
UDP
l
ICMP
l
ICMP6
l
Any
To configure a packet filtering rule:
Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in Use Digi Remote Manager to view and manage your
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
To Next Page
Loading...
Need help?
General
