Interfaces Wireless Wide Area Networks (WWANs)
IX10 User Guide
109
(config network interface my_wan surelink tests 1)> custom_
test_commands "string"
(config network interface my_wan surelink tests 1)>
n
tcp_connection: Tests that the interface can reach a destination port on the
configured host.
If tcp_connection is selected, complete the following:
l
Set the hostname or IP address of the host to create a TCPconnection to:
(config network interface my_wan surelink tests 1)> tcp_host
hostname/IP_address
(config network interface my_wan surelink tests 1)>
l
Set the TCP port to create a TCPconnection to.
(config network interface my_wan surelink tests 1)> tcp_port
port
(config network interface my_wan surelink tests 1)>
n
other: Tests the status of another interface.
If other is selected, complete the following:
l
Set the interface to test.
i. Use the ? to determine available interfaces:
ii. Set the interface. For example:
(config network interface my_wan surelink tests 1)> other_
interface /network/interface/eth1
(config network interface my_wan surelink tests 1)>
l
Set the type of IP connection:
(config network interface my_wan surelink tests 1)> other_ip_
version value
(config network interface my_wan surelink tests 1)>
where value is one of:
o
any: Either the IPv4 or IPv6 connection must be up.
o
both: Both the IPv4 or IPv6 connection must be up.
o
ipv4 The IPv4 connection must be up.
o
ipv6: The IPv6 connection must be up.
l
The status required for the test to past.
(config network interface my_wan surelink tests 1)> other_
status value
(config network interface my_wan surelink tests 1)>
where value is one of:
To Next Page
Loading...
Need help?
General
