Interfaces Wireless Wide Area Networks (WWANs)
IX10 User Guide
113
12. For Antennas, select whether the modem should use the main antenna, the auxiliary antenna,
or both the main and auxiliary antennas.
13. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX10
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Modem configurations are enabled by default. To disable:
(config)> network modem modem enable false
(config)>
4. Set the matching criteria used to determine if this modem configuration applies to the
currently attached modem:
(config)> network modem modem match value
(config)>
where value is one of the following:
n
any: Applies this configuration to any modem that is attached.
n
imei: Applies this configuration only to a modem that matches the identified IMEI.
l
If imei is used, set the IMEI of the modem that this configuration should be applied
to:
(config)> network modem modem imei value
(config)>
where value is the IMEI of the modem.
n
port: Applies this configuration to a modem attached to the identified physical port.
l
If port is used, set modem's port:
a. Determine available ports and correct syntax by using the ?:
(config)> network modem modem port ?
Match port: The physical port that the modem device is
attached to.
Format:
/device/usb/modem/module
Default value: /device/usb/modem/module
Current value: /device/usb/modem/module
(config)> network modem modem port
To Next Page
Loading...
Need help?
General
