Digi IX10 User Manual

Interfaces Wireless Wide Area Networks (WWANs)
IX10 User Guide
115
9. Carrier switching allows the modem to automatically match the carrier for the active SIM.
Carrier switching is enabled by default. To disable:
(config)> network modem modem carrier_switch false
(config)>
10. Set the type of cellular technology that this modem should use to access the cellular network:
(config)> network modem modem access_tech value
(config)>
Available options for value vary depending on the modem type. To determine available
options:
(config)> network modem modem access_tech ?
Access technology: The cellular network technology that the modem may
use.
Format:
2G
3G
4G
4GM
4GT
all
Default value: all
Current value: all
(config)>
The default is all, which uses the best available technology.
11. Set whether the modem should use the main antenna, the auxiliary antenna, or both the main
and auxiliary antennas:
(config)> network modem modem antenna value
(config)>
where value is one of the following:
n
main
n
aux
n
both
12. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
13. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Digi IX10 Specifications

General

Brand	Digi
Model	IX10
Category	Network Router
Language	English