Interfaces Local Area Networks (LANs)
IX10 User Guide
172
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in Use Digi Remote Manager to view and manage your
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Network > Interfaces.
4. Click to expand an existing LAN, or create a new LAN. See Configure a LAN.
5. Disable the DHCP server, if it is enabled:
a. Click to expand IPv4 > DHCP server.
b. Click Enable to toggle off the DHCP server.
6. Click to expand DHCP relay.
7. For Add DHCP Server:, click .
8. For DHCP server address, type the IP address of the relay server.
9. Repeat for each additional DHCP relay server.
10. Click Apply to save the configuration and apply the change.
Command line
To Next Page
Loading...
Need help?
General
