Serial port Configure Remote Access mode
IX10 User Guide
201
------------------------------
any
dynamic_routes
edge
external
internal
ipsec
loopback
setup
(config)>
Repeat this step to include additional firewall zones.
vi. (Optional) Enable Multicast DNS (mDNS):
(config)>serial port1 service ssh mdns enable true
(config)>
b. Configure TCP settings:
i. Enable TCP:
(config)>serial port1 service tcp enable true
(config)>
ii. Set the port to be used for ssh communications:
(config)>serial port1 service tcp port int
(config)>
where int is any integer between 1 and 65535. The default is 4001.
iii. Enable TCPkeep-alive messages:
(config)>serial port1 service tcp keepalive true
(config)>
iv. Set the option that initiates the connection:
(config)>serial port1 service tcp conn_type value
(config)>
where value is one of:
n
tcp
n
tls
n
tls_auth
The default is tls.
v. Enable TCP nodelay messages:
(config)>serial port1 service tcp nodelay true
(config)>
vi. (Optional) Configure access control:
To Next Page
Loading...
Need help?
General
