Digi IX10

Serial port Configure Remote Access mode
IX10 User Guide
203
n
To limit access based on firewall zones:
(config)> add serial port1 service tcp acl zone end value
(config)>
Where value is a firewall zone defined on your device, or the any keyword.
Display a list of available firewall zones:
Type ... firewall zone ? at the config prompt:
(config)> ... firewall zone ?
Zones: A list of groups of network interfaces that
can be referred to by packet
filtering rules and access control lists.
Additional Configuration
-------------------------------------------------
------------------------------
any
dynamic_routes
edge
external
internal
ipsec
loopback
setup
(config)>
Repeat this step to include additional firewall zones.
vii. (Optional) Enable Multicast DNS (mDNS):
(config)>serial port1 service tcp mdns enable true
(config)>
c. Configure telnet settings:
i. Enable SSH:
(config)>serial port1 service telnet enable true
(config)>
ii. Set the port to be used for ssh communications:
(config)>serial port1 service telnet port int
(config)>
where int is any integer between 1 and 65535. The default is 3001.
iii. Enable TCPkeep-alive messages: