Serial port Configure UDP serial mode
IX10 User Guide
224
filtering rules and access control lists.
Additional Configuration
----------------------------------------------------
---------------------------
any
dynamic_routes
edge
external
internal
ipsec
loopback
setup
(config)>
Repeat this step to include additional firewall zones.
n
To limit access to specified IPv4 addresses and networks:
(config)> add serial port1 udp acl address end value
(config)>
Where value can be:
l
A single IP address or host name.
l
A network designation in CIDR notation, for example, 192.168.1.0/24.
l
any: No limit to IPv4 addresses that can access the service-type.
Repeat this step to list additional IP addresses or networks.
n
To limit access to specified IPv6 addresses and networks:
(config)> add serial port1 udp acl address6 end value
(config)>
Where value can be:
l
A single IP address or host name.
l
A network designation in CIDR notation, for example, 2001:db8::/48.
l
any: No limit to IPv6 addresses that can access the service-type.
Repeat this step to list additional IP addresses or networks.
n
To limit access to hosts connected through a specified interface on the IX10 device:
(config)> add serial port1 udp acl interface end value
(config)>
Where value is an interface defined on your device.
Display a list of available interfaces:
To Next Page
Loading...
Need help?
General
