Routing IP routing
IX10 User Guide
260
any
dynamic_routes
edge
external
internal
ipsec
loopback
setup
Default value: any
Current value: any
(config network route policy 0)> dst zone
b. Set the zone. For example:
(config network route policy 0)> dst zone external
(config network route policy 0)>
See Firewall configuration for more information about firewall zones.
n
interface: Matches the destination IP address to the selected interface's network
address. Set the interface:
a. Use the ? to determine available interfaces:
b. Set the interface. For example:
(config network route policy 0)> dst interface
/network/interface/eth1
(config network route policy 0)>
n
address: Matches the destination IPv4 address to the specified IP address or network.
Set the address that will be matched:
(config network route policy 0)> dst address value
(config network route policy 0)>
where value uses the format IPv4_address[/netmask], or any to match any IPv4
address.
n
address6: Matches the destination IPv6 address to the specified IP address or network.
Set the address that will be matched:
(config network route policy 0)> dst address6 value
(config network route policy 0)>
where value uses the format IPv6_address[/prefix_length], or any to match any IPv6
address.
n
mac: Matches the destination MAC address to the specified MAC address. Set the MAC
address to be matched:
To Next Page
Loading...
Need help?
General
