Routing IP routing
IX10 User Guide
262
3. Click Network > Routes > Policy-based routing.
4. Click the to add a new route policy.
5. For Label, type Route through cellular.
6. For Interface, select .
7. Configure the source address:
a. Click to expand Source address.
b. For Type, select Zone.
c. For Zone, select Internal.
8. Configure the destination address:
a. Click to expand Destination address.
b. For Type, select IPv4 address.
c. For IPv4 address, type the IP address that will be the destination for outgoing traffic
routed through the WWAN interface. In the above example, this is 241.236.162.59.
To Next Page
Loading...
Need help?
General
