Digi IX10 User Manual

Routing IP routing
IX10 User Guide
265
3. Click Network > Routes > Policy-based routing.
4. Click the  to add a new route policy.
5. For Label, type Domain-based policy.
6. For Interface, select ETH1.
7. Configure the source address:
a. Click to expand Source address.
b. For Type, select Zone.
c. For Zone, select Any.
8. Configure the destination address:
a. Click to expand Destination address.
b. For Type, select Domain.
c. Click to expand Domains.
d. Click the  to add a new domain.
e. For Domain, type youtube.com.
You can add additional domains by repeating the last two steps.

Digi IX10 Specifications

General

Brand	Digi
Model	IX10
Category	Network Router
Language	English