Digi IX10

Virtual Private Networks (VPN) IPsec
IX10 User Guide
351
l
Set the TCP port to create a TCPconnection to.
(config vpn ipsec tunnel ipsec_example surelink tests 1)>
tcp_port port
(config vpn ipsec tunnel ipsec_example surelink tests 1)>
n
other: Tests the status of another interface.
If other is selected, complete the following:
l
Set the interface to test.
i. Use the ? to determine available interfaces:
ii. Set the interface. For example:
(config vpn ipsec tunnel ipsec_example surelink tests 1)>
other_interface /network/interface/eth1
(config vpn ipsec tunnel ipsec_example surelink tests 1)>
l
Set the type of IP connection:
(config vpn ipsec tunnel ipsec_example surelink tests 1)>
other_ip_version value
(config vpn ipsec tunnel ipsec_example surelink tests 1)>
where value is one of:
o
any: Either the IPv4 or IPv6 connection must be up.
o
both: Both the IPv4 or IPv6 connection must be up.
o
ipv4 The IPv4 connection must be up.
o
ipv6: The IPv6 connection must be up.
l
The status required for the test to past.
(config vpn ipsec tunnel ipsec_example surelink tests 1)>
other_status value
(config vpn ipsec tunnel ipsec_example surelink tests 1)>
where value is one of:
o
up: The test will pass only if the referenced interface is up and passing its
own SureLink tests (if applicable).
o
down: The test will pass only if the referenced interface is down or failing its
own SureLink tests (if applicable).
f. Repeat for each additional test.
6. Add recovery actions:
a. Type ... to return to the root of the configuration:
(config vpn ipsec tunnel ipsec_example surelink tests 1)> ...
(config)>