Digi IX10

Virtual Private Networks (VPN) IPsec
IX10 User Guide
355
l
Set the time to wait before the next test is run. If set to the default value of 0s,
the test interval is used.
(config vpn ipsec tunnel ipsec_example surelink actions 0)>
override_interval int
(config vpn ipsec tunnel ipsec_example surelink actions 0)>
n
reboot_device.
If reboot_device is selected, complete the following:
l
Set the number of attempts for this recovery action to perform, before moving
to the next recovery action:
(config vpn ipsec tunnel ipsec_example surelink actions 0)>
max_attempts int
(config vpn ipsec tunnel ipsec_example surelink actions 0)>
The default is 3.
l
Set the time to wait before the next test is run. If set to the default value of 0s,
the test interval is used.
(config vpn ipsec tunnel ipsec_example surelink actions 0)>
override_interval int
(config vpn ipsec tunnel ipsec_example surelink actions 0)>
n
custom_action: Execute custom recovery commands.
If custom_action is selected, complete the following:
l
Set the number of attempts for this recovery action to perform, before moving
to the next recovery action:
(config vpn ipsec tunnel ipsec_example surelink actions 0)>
max_attempts int
(config vpn ipsec tunnel ipsec_example surelink actions 0)>
The default is 3.
l
Set the commands to run to attempt to recovery connectivity.
(config network interface my_wan surelink actions 0)> custom_
action_commands_modem "string"
(config network interface my_wan surelink actions 0)>
l
Set the time to wait before the next test is run. If set to the default value of 0s,
the test interval is used.
(config vpn ipsec tunnel ipsec_example surelink actions 0)>
override_interval int
(config vpn ipsec tunnel ipsec_example surelink actions 0)>
g. Repeat for each additional recovery action.
7. Optional SureLink configuration parameters: