Virtual Private Networks (VPN) OpenVPN
IX10 User Guide
380
l
any: No limit to IPv6 addresses that can access the service-type.
d. Click again to list additional IP addresses or networks.
n
To limit access to hosts connected through a specified interface on the IX10 device:
a. Click Interfaces.
b. For Add Interface, click .
c. For Interface, select the appropriate interface from the dropdown.
d. Click again to allow access through additional interfaces.
n
To limit access based on firewall zones:
a. Click Zones.
b. For Add Zone, click .
c. For Zone, select the appropriate firewall zone from the dropdown.
See Firewall configuration for information about firewall zones.
d. Click again to allow access through additional firewall zones.
11. (Optional) Click to expand Advanced Options to manually set additional OpenVPN
parameters.
a. Click Enable to enable the use of additional OpenVPN parameters.
b. Click Override if the additional OpenVPN parameters should override default options.
c. For OpenVPN parameters, type the additional OpenVPN parameters.
12. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX10
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. At the config prompt, type:
(config)> add vpn openvpn server name
(config vpn openvpn server name)>
where name is the name of the OpenVPN server.
The OpenVPN server is enabled by default. To disable the server, type:
(config vpn openvpn server name)> enable false
(config vpn openvpn server name)>
To Next Page
Loading...
Need help?
General
