Digi IX10

Virtual Private Networks (VPN) OpenVPN
IX10 User Guide
410
l
Set the number of attempts for this recovery action to perform, before moving
to the next recovery action:
(config vpn openvpn client openvpn_client1 surelink actions
0)> max_attempts int
(config vpn openvpn client openvpn_client1 surelink actions
0)>
The default is 3.
l
Set the amount that the interface's metric should be increased. This should be
set to a number large enough to change the routing table to use another
default gateway.
(config vpn openvpn client openvpn_client1 surelink actions
0)> metric_adjustment_modem int
(config vpn openvpn client openvpn_client1 surelink actions
0)>
The default is 100.
l
Set the time to wait before the next test is run. If set to the default value of 0s,
the test interval is used.
(config vpn openvpn client openvpn_client1 surelink actions
0)> override_interval int
(config vpn openvpn client openvpn_client1 surelink actions
0)>
n
restart_interface.
If restart_interface is selected, complete the following:
l
Set the number of attempts for this recovery action to perform, before moving
to the next recovery action:
(config vpn openvpn client openvpn_client1 surelink actions
0)> max_attempts int
(config vpn openvpn client openvpn_client1 surelink actions
0)>
The default is 3.
l
Set the time to wait before the next test is run. If set to the default value of 0s,
the test interval is used.
(config vpn openvpn client openvpn_client1 surelink actions
0)> override_interval int
(config vpn openvpn client openvpn_client1 surelink actions
0)>
n
reset_modem: This recovery action is available for WWAN interfaces only.
If reset_modem is selected, complete the following: