Digi IX10

Virtual Private Networks (VPN) Generic Routing Encapsulation (GRE)
IX10 User Guide
429
(config vpn ipsec tunnel ipsec_gre1 policy 0)> remote network
172.30.0.2/32
(config vpn ipsec tunnel ipsec_gre1 policy 0)>
10. Save the configuration and apply the change:
(config ipsec tunnel ipsec_gre1 policy 0)> save
Configuration saved.
>
Task two: Create an IPsec endpoint interface
Web
1. Click Network > Interface.
2. For Add Interface, type ipsec_endpoint1 and click .
3. For Zone, select Internal.
4. For Device, select Ethernet: loopback.
5. Click to expand IPv4.
6. For Address, type the IP address of the local GRE tunnel, 172.30.0.1/32.
7. Click Apply to save the configuration and apply the change.
Command line