Virtual Private Networks (VPN) NEMO
IX10 User Guide
467
Remote Manager:
a. Locate your device as described in Use Digi Remote Manager to view and manage your
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click VPN > NEMO.
The NEMO tunnel is enabled by default. To disable, toggle off Enable.
4. For Home IP address, type the IPv4 address of the NEMO virtual network interface.
5. For Zone, select Internal.
The Internal firewall zone configures the IX10 device to trust traffic going to the tunnel and
allows it through the network.
6. For Home agent server IP address, type the IPv4 address of the NEMO home agent. This is
provided by your cellular carrier.
7. For Key, type the key used to authenticate to the home agent. This is provided by your cellular
carrier.
8. For Home agent SPI, type the Security Parameter Index (SPI) value, which is used in the
authentication extension when registering. This should be normally left at the default setting
of 256 unless your service provider indicates a different value.
9. For Home agent registration lifetime, in seconds, type the number of seconds number of
seconds until the authorization key expires. This is provided by your cellular carrier.
To Next Page
Loading...
Need help?
General
