Digi IX10 User Manual

Services Configure SSHaccess
IX10 User Guide
491
l
A single IP address or host name.
l
A network designation in CIDR notation, for example, 192.168.1.0/24.
l
any: No limit to IPv4 addresses that can access the SSH service.
d. Click  again to list additional IP addresses or networks.
n
To limit access to specified IPv6 addresses and networks:
a. Click IPv6 Addresses.
b. For Add Address, click .
c. For Address, enter the IPv6 address or network that can access the device's SSH
service. Allowed values are:
l
A single IP address or host name.
l
A network designation in CIDR notation, for example, 2001:db8::/48.
l
any: No limit to IPv6 addresses that can access the SSH service.
d. Click  again to list additional IP addresses or networks.
n
To limit access to hosts connected through a specified interface on the IX10 device:
a. Click Interfaces.
b. For Add Interface, click .
c. For Interface, select the appropriate interface from the dropdown.
d. Click  again to allow access through additional interfaces.
n
To limit access based on firewall zones:
a. Click Zones.
b. For Add Zone, click .
c. For Zone, select the appropriate firewall zone from the dropdown.
See Firewall configuration for information about firewall zones.
d. Click  again to allow access through additional firewall zones.
6. Multicast DNS (mDNS) is enabled by default. mDNS is a protocol that resolves host names in
small networks that do not have a DNS server. To disable mDNS, or enable it if it has been
disabled, click Enable mDNS.
7. For Private key, type the private key in PEM format. If Private key is blank, the device will use
an automatically-generated key.
8. To create custom SSHconfiguration settings:
a. Click to expand Custom configuration.
b. Click Enable.
c. For Override:
n
If Override is enabled, entries in Configuration file will be used in place of the
standard SSHconfiguration.
n
If Override is not enabled, entries in Configuration file will be added to the
standard SSHconfiguration.
d. For Configuration file, type configuration settings in the form of an OpenSSH sshd_config
file.

Digi IX10 Specifications

General

Brand	Digi
Model	IX10
Category	Network Router
Language	English