Services Location information
IX10 User Guide
525
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Services > Location > Location sources.
4. Click to add a location source.
5. (Optional) Type a Label for this location source.
6. For Type of location source, select User-defined location.
7. The location source is enabled by default. Click Enable the location source to disable the
location source, or to enable it if it has been disabled.
8. For Latitude, type the latitude of the device. Allowed values are -90 and 90, with up to six
decimal places.
9. For Longitude, type the longitude of the device. Allowed values are -180 and 180, with up to
six decimal places.
10. For Altitude, type the altitude of the device. Allowed values are an integer followed by m or
km, for example, 100m or 1km.
11. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX10
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
To Next Page
Loading...
Need help?
General
