User authentication Authentication groups
IX10 User Guide
684
n
Admin access
For groups assigned Admin access, you can also determine whether the Access level
should be Full access or Read-only access.
l
Full access provides users of this group with the ability to manage the IX10 device
by using the WebUI or the Admin CLI.
l
Read-only access provides users of this group with read-only access to the WebUI
and Admin CLI.
The default is Full access.
n
Serial access
n
Interactive shell access
Shell access is not available if the Allow shell parameter has been disabled. See Disable
shell access for more information about the Allow shell parameter.
6. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX10
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
To Next Page
Loading...
Need help?
General
