System administration Erase device configuration and reset to factory defaults
IX10 User Guide
824
3. In the Erase configuration section, click ERASE.
4. Click CONFIRM.
5. After resetting the device:
a. Connect to the IX10 by using the serial port or by using an Ethernet cable to connect the
IX10 ETH port to your PC.
b. Log into the IX10:
User name: Use the default user name: admin.
Password: Use the unique password printed on the bottom label of the device (or the
printed label included in the package).
c. (Optional) Reset the default password for the admin account. See Change the default
password for the admin user for further information.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX10
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Enter the following:
> system factory-erase
3. After resetting the device:
a. Connect to the IX10 by using the serial port or by using an Ethernet cable to connect the
IX10 ETH port to your PC.
b. Log into the IX10:
User name: Use the default user name: admin.
Password: Use the unique password printed on the bottom label of the device (or the
printed label included in the package).
c. (Optional) Reset the default password for the admin account. See Change the default
password for the admin user for further information.
Reset the device by using the ERASE button.
To Next Page
Loading...
Need help?
General
