Digi IX10 User Manual

System administration Schedule system maintenance tasks
IX10 User Guide
842
l
If the duration length is set to one or more hours, the minutes field in the
start time is ignored and the duration window will begin at the beginning
of the specified hour.
ii. Configure the duration length (the amount of time that the maintenance tasks
will be run). If 0 is used, all scheduled tasks will begin at the start time, defined
in the previous step.
(config system schedule maintenance trigger 0)> length num
(config system schedule maintenance trigger 0)>
where num is any whole number between 0 and 24.
iii. Configure the frequency that the maintenance tasks should be run:
(config system schedule maintenance trigger 0)> frequency
value
(config system schedule maintenance trigger 0)>
where value is either daily or weekly. Daily is the default.
4. If Central Management is disabled, configure the device to look for any updated device
firmware during the maintenance window. If updated firmware is found, it will then be
installed. The device will look for updated firmware both on the local device and over the
network, using either a WAN or cellular connection.
This options is only available if Central Management is disabled; see Central management for
more information.
(config)> system schedule maintenance device_fw_update true
(config)>
5. If Central Management is disabled, configure the device to look for any updated modem
firmware during the maintenance window. If updated firmware is found, it will then be
installed. The device will look for updated firmware both on the local device and over the
network, using either a WAN or cellular connection.
This options is only available if Central Management is disabled; see Central management for
more information.
(config)> system schedule maintenance modem_fw_update true
(config)>
6. (Optional) Configure automated checking for device firmware updates:
a. Device firmware update check is enabled by default. This enables to automated
checking for device firmware updates. To disable:
(config)> system schedule maintenance firmware_update_check device
false
(config)>
b. Set how often automated checking for device firmware should take place:
(config)> system schedule maintenance frequency value
(config)>

Digi IX10 Specifications

General

Brand	Digi
Model	IX10
Category	Network Router
Language	English