Command line interface Configuration mode
IX10 User Guide
963
(config)> save
Configuration saved.
>
4. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Revert a subset of configuration changes to the default settings
There are two methods to revert a subset of configuration changes to the default settings.
n
Enter the revert command with the path parameter. For example, to revert all changes to the
authentication methods configuration:
1. Enter the revert command with the path set to auth method:
(config)> revert auth method
(config)>
2. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access
selection menu. Type quit to disconnect from the device.
n
Move to the location in the configuration and enter the revert command without the path
parameter. For example:
1. Change to the auth method node:
(config)> auth method
(config auth method)>
2. Enter the revert command:
(config auth method)> revert
(config auth method)>
3. Save the configuration and apply the change:
(config auth method)> save
Configuration saved.
>
4. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access
selection menu. Type quit to disconnect from the device.
To Next Page
Loading...
Need help?
General
