Interfaces Wireless Wide Area Networks (WWANs)
IX10 User Guide
97
(config network interface my_wwan surelink tests 1)>
interface_timeout value
(config network interface my_wwan surelink tests 1)>
where value is any number of weeks, days, hours, minutes, or seconds, and
takes the format number{w|d|h|m|s}.
For example, to set interface_timeout to ten minutes, enter either 10m or
600s:
(config network interface my_wwan surelink tests 1)>
interface_timeout 600s
(config)>
n
custom_test: Tests the interface with custom commands.
If custom_test is set, set the commands to run to perform the test:
(config network interface my_wwan surelink tests 1)> custom_
test_commands "string"
(config network interface my_wwan surelink tests 1)>
n
tcp_connection: Tests that the interface can reach a destination port on the
configured host.
If tcp_connection is selected, complete the following:
l
Set the hostname or IP address of the host to create a TCPconnection to:
(config network interface my_wwan surelink tests 1)> tcp_host
hostname/IP_address
(config network interface my_wwan surelink tests 1)>
l
Set the TCP port to create a TCPconnection to.
(config network interface my_wwan surelink tests 1)> tcp_port
port
(config network interface my_wwan surelink tests 1)>
n
other: Tests the status of another interface.
If other is selected, complete the following:
l
Set the interface to test.
i. Use the ? to determine available interfaces:
ii. Set the interface. For example:
(config network interface my_wan surelink tests 1)> other_
interface /network/interface/eth1
(config network interface my_wan surelink tests 1)>
To Next Page
Loading...
Need help?
General
