DIGIPLEX CONTROL PANEL 15
4.7 PARADOX MEMORY KEY
Copy the programmed contents of one Digiplex Control Panel into
the Paradox Memory Key. Then copy the contents of the Paradox
Memory Key into as many Digiplex Control Panels as you need.
This saves you a lot of time. All you have to do is program one
Digiplex Control Panel, then download the programmed contents to
other control panels in less than 5 seconds.
Copy to Memory Key from SOURCE Control Panel
1) Remove the AC and battery
power from the control panel.
2) Place Memory Key on the
connector labeled MEM KEY of
the control panel that you
want to copy. Make sure that
the write protect jumper is on.
3) Enter section:
[965] to copy the contents of the panel except sections
[001] to [048] (device serial numbers) and [049] to
[056] (keyswitch serial numbers) to the key.
[966] to copy all of the contents including sections [001]
to [048] and [049] to [056] from the panel to the key.
4) When the keypad emits a Confirmation Beep, wait 10
seconds before removing the Memory Key. Remove the
jumper if you do not wish to accidentally overwrite the
contents of the Memory Key.
Download to DESTINATION Control Panel
1) Remove the AC and battery
power from the control panel.
2) Place the Memory Key on the
connector labeled MEM KEY of
the control panel that is to
receive the contents of the
Memory Key.
3) Enter section:
[961] to download the contents except sections [001] to
[048] (device serial numbers) and [049] to [056]
(keyswitch serial numbers) from the key to the
panel.
[962] to download all of the contents including sections
[001] to [048] and [049] to [056] from the key to the
panel.
4) When the keypad emits a Confirmation Beep, wait 10
seconds before removing the Memory Key.
Figure 4-1: Using the Memory Key
To Next Page
Loading...