Digiplex DGP-48 - Auto Report Code Programming; Automatic Report Code Setup

DIGIPLEX CONTROL PANEL 33
9.13 AUTO REPORT CODE PROGRAMMING
SECTIONS [790] TO [795]
When using either the Contact ID or SIA Reporting Formats (see
section 9.5), the Digiplex system can automatically program a set
of default report codes. From programming mode (see section 4.1)
enter any of the following sections to set the indicated report
codes:
ALL CODES
Section [790]
Sets all report codes in sections [600] to [718] with the default
values from the Automatic Report Codes List in the Programming
Guide.
ARMING & DISARMING CODES
Section [791]
Sets all report codes in sections [600] to [654] with the default
values from the Automatic Report Codes List in the Programming
Guide.
ALARM RESTORE CODES
Section [792]
Sets all report codes in sections [655] to [680] with the default
values from the Automatic Report Codes List in the Programming
Guide.
TAMPER & TAMPER RESTORE CODES
Section [793]
Sets all report codes in sections [681] to [705] with the default
values from the Automatic Report Codes List in the Programming
Guide.
TROUBLE RESTORE CODES
Section [794]
Sets all report codes in sections [706] to [716] with the default
values from the Automatic Report Codes List in the Programming
Guide.
SPECIAL CODES
Section [795]
Sets all report codes in sections [717] to [718] with the default
values from the Automatic Report Codes List in the Programming
Guide.
Please note that even after automatic report codes have been set,
you can still use the manual programming method (see section
9.5.3 & section 9.5.4) to program remaining report codes or change
some of the defaults.