DIGIPLEX CONTROL PANEL 5
2 ACCESSORIES
The following modules are compatible with the Digiplex DGP-48 Control Panel.
WINLOAD
This Windows
®
-based Security System Management Software can perform remote diagnostics and
adjustments, provide on-site communication at 300baud with the ADP-1 or at 19,200 baud with the
306 Adapter, facilitate programming and event loading, and customize control panel default settings.
This user-friendly software is compatible with most modems.
LCD KEYPAD (DGP-641)
48-zone, 32-character programmable LCD keypad that connects to the bus. Most messages in the
LCD keypad are programmable. View zone, event and trouble status for one or more partitions,
display entry/exit delay, adjust contrast, backlight, and many other features. On-board PGM output
and hardwired zone input.
ACCESS CONTROL LCD KEYPAD (DGP-641ACC)
The DGP-641ACC is an LCD Keypad that can be used with the Access Control feature available
through the Digiplex Control Panel. The Access Control feature allows you to monitor and control the
access of up to 32 doors in the Digiplex system. The DGP-641ACC is the same as a DGP-641
except it allows you to program the access control features, view logged access events as well as
communicate the status of a Posiprox (CR-R880) card reader, a Paradoor (460), a door lock, and a
door contact to the Digiplex system.
LED KEYPADS (DGP-610, DGP-620 & DGP-648)
The cost-effective 10-zone, 20-zone and 48-zone LED keypads connect to the bus and provide a
user-friendly display of the system's status. Includes an on-board PGM output and hardwired zone
input. This modern and stylish keypad will enhance any decor while helping you make the most of the
Digiplex security system.
ZX1 ZONE EXPANSION BUS MODULE (DGP-ZX1)
Connected to the Digiplex communication bus, this fully supervised zone expansion module will add
1 hardwired input terminal to the Digiplex System (2 zones if ATZ is enabled).
ZX8 ZONE EXPANSION MODULE (DGP-ZX8)
Connected to the Digiplex communication bus, this zone expansion module will add 8 hardwired
input terminals to the Digiplex System (16 zones if ATZ is enabled). Each module has one on-board
PGM output.
PGM1 EXPANSION MODULE (DGP-PGM1)
When connected to the Digiplex communication bus, this module will add one 5A programmable
output (PGM) to the Digiplex System.
ZX4 ON-BOARD ZONE MODULE (DGP-ZX4)
Connected to the Digiplex control panel's EXPANSION input, this module will add 4 hardwired input
terminals to the Digiplex System (8 zones with ATZ enabled).
To Next Page
Loading...