DIGITAL-LOGIC AG PCCP5 Manual V2.3
126
Procedure example
Run esscfg.exe and use the following settings:
IRQ = 7
DMA = 1
2nd DMA = 0
Adr. = 220
1) All other = disabled
2) Reboot the system
3) Add a VESA driver (vesa.com) to the autoexec.bat
(Necessary when using the shareware "SUPERSONIC" and if grafic controller is set to Vesa LocalBus)
4) Install des program SUPERSONIC with install.exe and configure the devices afterwards with the
setup.exe
(When using the SBPRO driver, one can also record)
5) Add a mouse driver in the autoexec.bat if SUPERSONIC does not detect any
EXAMPLES:
AUTOEXEC.BAT
C:\SOUND\ESSCFG.EXE /A:220 /I:7 /D:1 /E:0 /B:D /J:E
@ECHO OFF
PROMPT $p$g
PATH C:\DOS;c:\ss;c:\sound;
SET TEMP=C:\DOS
MODE CON CODEPAGE PREPARE=((850) C:\DOS\EGA.CPI)
MODE CON CODEPAGE SELECT=850
KEYB SG,,C:\DOS\KEYBOARD.SYS
vesa.com
lmouse.com
CONFIG.SYS
DEVICE=C:\DOS\SETVER.EXE
DEVICE=C:\DOS\HIMEM.SYS /testmem:off
DOS=HIGH
COUNTRY=041,,C:\DOS\COUNTRY.SYS
DEVICE=C:\DOS\DISPLAY.SYS CON=(EGA,,1)
FILES=30
rem DEVICE=C:\SOUND\ES1868.COM /A:0 /I:0
11.2 WIN311, OS2, WIN95, WIN98, WIN NT
For all the other operating systems (OS), please run the setup program to install the appropriate drivers, if
not already recognized by the OS.
Note, that depending on the BIOS, one has might to reserve certain IRQ's to avoid corruptions with other
devices.
To Next Page
Loading...
