DIGITAL-LOGIC AG PCCP5 Manual V2.3
143
state specified in the Hard Disk Power Down Mode option (see the previ-
ous selection). The settings are Disabled or 1-14 min.
Standby Timeout
(Minutes)
This option specifies the length of a period of system inactivity while in Full
power on state. When this length of time expires, the computer enters
Standby power state. The settings are Disabled or 1-14 min.
Suspend Timeout
(Minutes)
This option specifies the length of a period of system inactivity while in
Standby state. When this length of time expires, the computer enters Sus-
pend power state. The settings are Disabled or 1-14 min.
Slow Clock Ratio This option specifies the speed at which clock runs in power saving states.
The settings are expressed as a percentage of the standard clock speed.
The settings are 1:1, 1:2, 1:4, 1:8, 1:16, 1:32, 1:64 or 1:128.
IRQ3/4/5/7/9/10/11/12/13/14
Active (at suspend)
When set to Monitor, these optins enable event monitoring on the specified
hardware interrupt request line. If set to Monitor and the computer is in a
power saving state, AMIBIOS watches for activity on the specified IRQ line.
The computer enters the full on power state if any activity occurs. AMIBIOS
reloads the Strandby and Suspend timeout timers if activity occurs on the
specified IRQ line. No monitoring activity if the option is set to Ingore. The
settings for each of these options are Monitor, Ignore, Wakeup or Both.
To Next Page
Loading...
