Digital Projection E-Vision Laser 5000 XGA - Settings 2 Menu

Digital Projection
E-V ISION L ASER 5000 S ERIES U SER M ANUAL R EV A J ANUARY 2018
40
Settings 2 Menu
Press the MENU button to open the OSD menu. Press the cursor  button to move to the Settings 2
menu. Press the cursor  button to move up and down in the Settings 2 menu.
ITEM DESCRIPTION
Auto Source
Press the cursor  button to enter and enable or disable the automatic source
detection function.
No Signal Power
Off (min.)
Press the cursor  button to enter and set automatic shutdown of the Light source
when no signal is present.
Auto Power On
Press the cursor  button to enter and enable or disable automatic power On when
AC power is supplied.
Light Mode
Press the cursor  button to enter and select the Light mode for higher brightness
or lower brightness.
Reset All Press (Enter) /  to reset all settings to default values.
Status
Press (Enter) /  to enter the Status menu.
See page 41 for more information on Status.
Advanced 1
Press (Enter) /  to enter the Advanced 1 menu.
See Advanced 1 Feature on page 42.
Advanced 2
Press (Enter) /  to enter the Advanced 2 menu.
See Advanced 2 Feature on page 56.
Custom Light
In Custom Light mode press the cursor  button to enter and adjust the brightness
of the projectors Light source.
Note: When Light Mode is set to Custom Light, the Custom Light function is Enabled.
Note :
In the Extreme Dimming mode you can save 50% of the light source power consumption by displaying
a blank screen (press the BLANK button)