Digital Projection E-Vision Laser 5000 XGA - Starting and Shutting Down the Projector

Digital Projection
E-VISION LASER 5000 SERIES USER MANUAL REV A JANUARY 2018
11
Remote Control Operating Range
The remote control uses infrared transmission to control the projector. It is not necessary to point the
remote directly at the projector. Provided you are not holding the remote perpendicular to the sides or the
rear of the projector, the remote will function well within a radius of approximately 7 meters (23 feet) and
15 degrees above or below the projector level. If the projector does not respond to the remote control, try
to move closer to the projector.
Projector and Remote Control Buttons
The projector can be operated using the remote control or the buttons on the top of the projector. All
operations can be carried out with the remote control; however, the buttons on the projector are limited in
use.