Digital Projection E-Vision Laser 5000 XGA - Setting an Access Password (Security Lock)

Digital Projection
E-VISION LASER 5000 SERIES USER MANUAL REV A JANUARY 2018
13
Starting and Shutting down the Projector
1.
Securely connect the power cord and
signal cables. When AC power is
connected, the POWER LED will
illuminate green.
2.
Turn on the light source by pressing “
” button on the projector or “ ”
on the remote control.
The POWER LED will now flash green
until the startup screen displays in
approximately 30 seconds.
The first time you use the projector, you
can select your preferred language
choice from the quick menu after the
startup screen display. (See Setting the
OSD Language on page 23)
Startup screen display Logo:
See Setting an Access Password
(Security Lock) on page 15 if security lock
is required to be enabled.