Digital Projection E-Vision Laser 5000 XGA - Rear View

Digital Projection
E-VISION LASER 5000 SERIES USER MANUAL REV A JANUARY 2018
4
Rear view
ITEM LABEL DESCRIPTION SEE PAGE
1.
HDMI 1 Connect a HDMI cable from a HDMI device.
2.
RJ45 Connect a LAN cable from Ethernet.
3.
HDMI 2 Connect a HDMI cable from a HDMI device.
4.
HDBaseT
Connect a Cat5e/Cat6 cable from a HDBaseT TX Box (VIDEO
EXTENDER) for reception of a HDBaseT signal.
5.
HDMI 3 / MHL
Connect a HDMI/MHL cable from a HDMI/MHL device.
Note: Set the Source to HDMI 3/MHL, this input will also charge the
connected MHL compatible device as long as the projector is
powered On.
6.
MONITOR OUT Connect an RGB cable to a display.
7.
COMPUTER Connect an RGB cable from a computer or a video enabled device.
8.
VIDEO Connect a composite cable from a video device.
9.
3D-SYNC Connect a 3D-sync in cable from a computer or an enabled device.
10.
SERVICE For service personnel use only.
11.
USB POWER (5V/1.5A)
Connect a USB cable for powering a USB powered device.
Note: Supports 5V/1.5A output as long as the projector power is On.