Memory: Select Memory from the Main menu, then press ENTER to recall image quality settings previously saved, or
to save changed settings in any of four memory locations.
• Recall Memory: Select Recall Memory from the Memory menu to recall saved image quality settings. Unless you
select Default (see below), this control affects all sources, not just the active source.
• User Memory 1 and User Memory 2 contain the factory default settings when the projector is initially turned on.
• Choose Default to restore the factory-default settings for the active source only. The other sources are
unaffected.
• Save Settings: Select Save Settings from the Memory menu to save any image-related settings you have changed
to User Memory 1 or User Memory 2.
To Next Page
Loading...
