Digitalchina Networks DCS-3950 series User Manual

108
DCS-3950 series Ethernet switch manual
4. Configure attributes of the cluster in the candidate switch
5. Remote cluster network management
6.2.2 Clustering Configuration Command List
6.2.2.1 cluster run
Command: cluster run
no cluster run
Function: Enable the clustering mode. While no is to disable the command.
Parameters: None.
Command mode: Global Mode.
Default: Clustering is enabled by default.
Usage Guide: This command is used to start the clustering service. Clustering
commands can be configured only if clustering is disabled.
Example: Disable the clustering service on the switch.
cluster auto-add enable
no cluster auto-add enable
Enable or disable adding newly discovered
candidate switch to the cluster
cluster holdtime < second>
no cluster holdtime
Set holdtime of heartbeat of the cluster
cluster heartbeat <interval>
no cluster heartbeat
Set interval of sending heartbeat packets
among the switches of the cluster
clear cluster candidate-table
Clear the list of candidate switches
discovered by the commander switch
Command Explanation
Global Mode
cluster register timer <timer-value>
no cluster register timer
Set interval of sending cluster register
packet
Command Explanation
Admin Mode
rcommand member <mem-id>
In the commander switch, this command is
used to configure and manage member
switches.
rcommand commander
In the member switch, this command is
used to configure the member switch itself.
cluster reset member<mem-id>
In the commander switch, this command is
used to reset the member switch.
cluster update member <mem-id>
<src-url> <dst-url> [ascii | binary]
In the commander switch, this command is
used to remotely upgrade the member
switch.

Digitalchina Networks DCS-3950 series Specifications

General

Brand	Digitalchina Networks
Model	DCS-3950 series
Category	Network Router
Language	English