18
DCS-3950 series Ethernet switch manual
Chapter 3 Setup Configuration
Setup configuration refers to the initial operation to the switch after the user
purchases the switch. For first-time users of the DCS-3950 series, this chapter provides a
very practical instruction. When using the CLI (command line interface), the user can type
setup under admin mode to enter the Setup configuration interface.
3.1 Setup Configuration
Setup configuration is done via menu selections, in which switch hostname, Vlan1
interface, Telnet service, Web service, and SNMP, can be configured.
3.2 Main Setup Menu
Before entry into the main menu, the following screen will be displayed to prompt the
user to select a preferred interface language. English users should choose ‘0’ to enter the
English interface, while Chinese users can choose ‘1’ to view the interface in Chinese.
Please select language
[0]: English
[1]: Chinese
Selection (0|1)[0]:
The main Setup configuration menu is listed below:
Configure menu
[0]: Config hostname
[1]: Config interface-Vlan1
[2]: Config telenet-server
[3]: Config web-server
[4]: Config SNMP
[5]: Exit setup configuration without saving
[6]: Exit setup configuration after saving
Selection number:
3.3 Setup Submenu
3.3.1 Configuring switch hostname
Select ‘0’ in the Setup main menu and press Enter, the following screen appears:
Please input the host name [switch]:
Note: the hostname entered should be less than 30 characters. If the user presses
To Next Page
Loading...
Need help?
General